Skip to main content
    Electrical Comparison Guide

    Metal vs Plastic Consumer Unit: UK Regulations & Which You Need

    Since January 2016 (Amendment 3 to BS 7671), all new consumer units in UK homes must be metal-clad or housed in a non-combustible enclosure. If you still have a plastic consumer unit, here's what you need to know about compliance, safety, and upgrading.

    07889 702799

    Metal-Clad Consumer Unit vs Plastic Consumer Unit: Side-by-Side

    UK Regulation Status

    Metal-Clad Consumer Unit

    ✅ Current standard since Jan 2016

    Plastic Consumer Unit

    ❌ No longer compliant for new installs

    Fire Safety

    Metal-Clad Consumer Unit

    Non-combustible — contains fire

    Plastic Consumer Unit

    Can melt or ignite in fault conditions

    Typical Cost

    Metal-Clad Consumer Unit

    £400-£800 installed

    Plastic Consumer Unit

    N/A — cannot be newly installed

    Durability

    Metal-Clad Consumer Unit

    Extremely robust, long-lasting

    Plastic Consumer Unit

    Can become brittle over time

    EICR Result

    Metal-Clad Consumer Unit

    Satisfactory

    Plastic Consumer Unit

    C3 recommendation to upgrade

    Insurance

    Metal-Clad Consumer Unit

    Meets all insurer requirements

    Plastic Consumer Unit

    Some insurers require upgrade

    Property Sale

    Metal-Clad Consumer Unit

    No issue for buyers/surveyors

    Plastic Consumer Unit

    May raise concerns in surveys

    RCD Protection

    Metal-Clad Consumer Unit

    Modern split-load with dual RCDs

    Plastic Consumer Unit

    Often lacks adequate RCD protection

    Circuit Capacity

    Metal-Clad Consumer Unit

    Designed for modern electrical loads

    Plastic Consumer Unit

    May lack capacity for new circuits

    Metal-Clad Consumer Unit: The Current Standard

    Metal-clad consumer units became the UK standard in January 2016 under Amendment 3 to BS 7671 (18th Edition Wiring Regulations). The key requirement is that the enclosure must be made of non-combustible material — meaning steel or metal, not plastic. This change was driven by fire safety concerns after analysis of domestic electrical fires.

    💰 £400-£800 installed⏱️ 4-6 hours

    Ideal for: Every UK home. All new installations and replacements must use metal-clad units. If you're adding an EV charger, extending your home, or upgrading your electrics, a metal-clad consumer unit is required.

    Pros

    • Compliant with current UK regulations (18th Edition BS 7671)
    • Non-combustible — contains any internal fire or arc fault
    • Modern split-load design with dual RCD protection
    • Adequate capacity for modern electrical demands
    • Meets all mortgage lender and insurance requirements
    • Available with RCBO protection for individual circuit isolation
    • Satisfies EICR inspection requirements

    Cons

    • Higher cost than old plastic units (but plastic can't be newly installed)
    • Slightly larger physical size than some older units
    • Must be installed by qualified electrician (not DIY)

    Plastic Consumer Unit: Legacy Units

    Plastic consumer units were standard in UK homes for decades before the 2016 regulation change. While existing plastic units don't need to be immediately replaced (they're "grandfathered"), they cannot be newly installed and will be flagged as a C3 recommendation on any EICR inspection.

    💰 N/A — not available for new installation⏱️ N/A

    Ideal for: N/A — plastic consumer units should not be chosen for any new installation. Existing units should be upgraded when convenient, especially when adding new circuits or selling your property.

    Pros

    • No immediate legal requirement to replace if existing
    • Still functional if wiring and circuits are in good condition
    • Replacement isn't urgent if EICR otherwise satisfactory

    Cons

    • Cannot be newly installed — doesn't meet 2016+ regulations
    • Combustible — can melt or ignite during electrical faults
    • Flagged as C3 on EICR inspections
    • Some insurers require upgrade for full cover
    • May concern buyers and mortgage surveyors
    • Often lacks modern RCD protection
    • May not have capacity for new circuits (EV charger, etc.)

    Our Verdict

    Metal-clad consumer units are now the UK standard and legally required for all new installations and replacements since January 2016. If you still have a plastic unit, it doesn't mean it's immediately dangerous — but it should be on your upgrade list, especially if you're adding circuits (EV charger, extension), selling your home, or your EICR identifies it as a C3 recommendation. The upgrade is straightforward (£400-£800) and usually completed in 4-6 hours.

    Frequently Asked Questions